Cure on Radiant Quartz Heat Solutions

Preventing Surface Skinning in Powder Curing via Inside Out Infrared Heating

Fri, 04 Sep 2026 14:14:03 +0800

Dealing with that annoying “skin” in powder coating

Ever pull a part out of the oven and see those tiny pinholes or bubbles? It’s frustrating. Usually, it happens because the surface dried too fast, creating a “skin” that traps gases and solvents inside. It might look okay at first glance, but since the base didn’t bond properly, the whole thing can just peel right off. We found a way to fix this by changing how the heat actually hits the part.

Optimizing Solvent Extraction in Powder Coating Using High Density Infrared Lamps

Wed, 02 Sep 2026 20:32:04 +0800

How to keep your gloss without wasting energy

Getting solvents out of a powder coating without killing that mirror-like finish is a total balancing act. Most of us have been there: you bake it too hot or leave it in too long, and suddenly your gloss is gone, leaving you with a dull, flat finish that looks cheap. We use Heraeus replacement lamps to hit that sweet spot. It’s about getting the solvents to flash off quickly without burning through your electricity bill.